Replace the lift motor of the base
Open the front door and take out the waste box, cartridge rack and T-rack.
1. Unplug the power connector to the lift motor.
2. Screw off the six screws on the liquid container above the heating module (2mm
Hex wrench).
3. Screw off the two screws on the metal sheet of the motor (3mm Hex wrench).
4. Screw off the two screws on the timing gear (2.5mm Hex wrench).
5. Screw off the four fixation screws on the motor (2.5mm Hex wrench).
6. Replace a new lift motor.
7. Install the new lift motor on the machine.
8. Note that the belt should be a little tight after installation.
RBCBioscience
56