INSTALLATION
2.5.4
C-BOX 4X0 Configuration for DeviceNet Slave Node
In order to setup the C-BOX 4X0, you need to install the function blocks in your PLC
programming software and configure it.
The procedure below can be generally applied for this purpose:
1.
Start the DeviceNet configurator on the Master.
2.
Insert the CD-ROM with the Electronic Data Sheet (.EDS) file into the drive of
the programming device (usually a PC).
3.
Load the .EDS file in the configurator.
4.
Configure the C-BOX 4X0 (through WinHost) setting the parameters according
to the DeviceNet network application as described in the configurator's Help On-
Line or User's Manual.
Further information on DeviceNet protocol and Flow control is
provided in the C-BOX 400/410 DeviceNet document and Help On-
Line installed from the configuration CD-ROM provided in the C-BOX
package.
NOTE
2
15