Opening The Device - Datalogic C-BOX 400 Installation Manual

2
2.2

OPENING THE DEVICE

To install the C-BOX 4X0 or during normal maintenance, it is necessary to open it by
unscrewing the four cover screws:
The C-BOX 4X0 must be disconnected from the power supply
during this operation.
CAUTION
It is possible to perform the following operations:
•
Proceed with the cable connections (see paragraph 2.4.2).
•
Set the DeviceNet Node Address (MAC ID) selection on the rotary switches.
•
Set the DeviceNet Baud Rate on the specific rotary switch.
•
Mount the C-BOX 4X0 to a wall or panel.
4
C-BOX 4X0
Figure 2 - Opening the C-BOX 4X0
C-BOX 400/410