Advertisement
September 2020
5
Configuration
5.1
Overview
This section contains information on how to setup a Rosemount
System Hub in a Rosemount Tank Gauging System. The description is based
on using the TankMaster Winsetup configuration program.
5.2
Safety messages
Instructions and procedures in this section may require special precautions
to ensure the safety of the personnel performing the operations.
Information that potentially raises safety issues is indicated by a warning
symbol (
operation preceded by this symbol.
WARNING
Failure to follow safe installation and servicing guidelines could result in
death or serious injury.
•
Ensure only qualified personnel perform the installation.
•
Use the equipment only as specified in this manual. Failure to do so may
impair the protection provided by the equipment.
•
Do not perform any service other than those contained in this manual
unless you are qualified.
5.3
Setting up a Rosemount 2460 System Hub
5.3.1
Introduction
A Rosemount 2460 System Hub is easy to install and configure by using the
TankMaster Winsetup configuration program. The WinSetup installation
wizard guides you through the basic configuration to start up a Rosemount
2460.
Host communication via the Ethernet 1 port (ETH1) and Modbus TCP
protocol can be setup by using the Web based Graphical User Interface
(GUI). See the Rosemount 2460
Quick Start Guide
). Refer to the following safety messages before performing an
Reference Manual
Quick Start Guide
™
2460
for more information.
35
Advertisement
