Advertisement
Quick Start Guide
5.3.2
Installation procedure
Installation of a Rosemount 2460 System Hub in a Rosemount Tank Gauging
system includes the following basic steps:
Procedure
1. Ensure that a plan is available for all tanks and devices with tag
names, communication addresses, number of temperature elements
and other data that is needed for a system setup.
2. In case devices from other vendors will be connected see the
Rosemount 2460
3. Make sure that the Rosemount 2460 is properly wired and up and
running. Check that the Power LED is on and the Status LED indicates
normal operation.
4. (Redundancy). Make sure that the two system hubs are properly
wired as described in Wiring. See also
Note
Note that configuration of redundant Rosemount 2460 is supported
by TankMaster 6.D0 and higher versions.
5. Ensure that the TankMaster WinSetup configuration program is up
and running.
6. In TankMaster WinSetup, setup the appropriate protocol channel
the TankMaster host PC. This step will ensure that communication
between the TankMaster PC and the Rosemount 2460 is established.
7. In TankMaster WinSetup, start the device installation wizard and
configure the system hub:
See the Rosemount Tank Gauging
(2)
information on how to configure communication protocol channels.
36
Reference Manual
a) In the WinSetup workspace, click the right mouse button on
the Devices folder and select Install new.
b) Specify device type (2460) and name tag.
c) Check that the correct communication channel is enabled
and verify communication with the TankMaster host
computer.
d) Verify that the Host ports and Field ports are using the right
protocols for communication with TankMaster work stations
or other host systems, and with field devices such as the
Rosemount 2410 Tank Hub and the Rosemount 5900S Radar
Level Gauge.
for more information.
Figure
System Configuration Manual
September 2020
4-16.
for more
Rosemount 2460 Tank Hub
(2)
in
Advertisement
