Table of Contents
Advertisement
TROUBLE SHOOTING
PROBLEM
Speed is not right
No power
Abnormal motor control
Engine burned out
Slope is not right
Power failure
No screen display
LCD screen display
Sceen display is poor
Virtufit TR-100 Treadmill
Solution:
Take E03 as an example.
Solution:
•
Check if the fuse is good.
•
Check that the entire connection cable is properly connected to the
console.
Solution:
•
Check if the motor is normal or replace the motor.
•
Confirm that the motor has no problems.
Solution:
•
Check if the console is also burnt out.
•
Replace the motor.
•
Replace the console.
Solution:
Check if the slope motor wire and 3 pin wire is properly
connected to the console, if that is okay, please do as follows:
1.
Remove the computer cable installed on the console (security key), turn
on the device, press the small key the right corner of the controller for 2
seconds.
2.
Release the button, the ramp motor will detect itself stating it the device
at the highest incline and after a while again will drop to the lowest
incline.
3.
If the motor hits the ground after 3 seconds, it is automatic detection
process over.
4.
After automatic detection, close the computer (or security key) on,
operate the computer function and test that the incline function works.
5.
Or replace the console.
Solution:
Check if the wire is connected properly.
Solution:
•
Check that the voltage is correct.
•
Check if the power supply is 8V, change the console, if not, change the
computer.
Solution:
•
Check if the power is good.
•
Check if the power supply is 8V, change the console, if not, change the
computer.
Solution:
First turn off the device, restart the engine, see if the screen is
back to normal, if not, take out the computer and the fixed PCB.
EN
SOLUTION
17
Advertisement
Table of Contents
