Table of Contents
Advertisement
G O B O I N S T A L L A T I O N
REPLACING A ROTATING GOBO
Locate the specific Rotating GOBO to replace. Carefully grip the GOBO using your thumb and index
GOBO Wheel.
finger, gently lift it slightly, and then pull it out and away until it fully clears the
Locate the tab of the spring, and with a precision pick (or similar tool), carefully press the retaining
spring inward to relieve the tension. Remove the retaining spring and carefully separate the GOBO from
the GOBO Holder. Lastly, remove the flat washer attached to the removed GOBO and attach it to the
desired replacement GOBO. Install the replacement Rotating GOBO following the steps above in
reverse order.
CAUTION: TAKE CARE NOT TO SCRATCH GOBO OR GOBO HOLDER
REPLACING A STATIC GOBO
Rotate the Static GOBO Wheel until the desired GOBO is visible through the OPEN slot in the Rotating
GOBO Wheel. Using a precision pick (or similar tool), carefully press the Static GOBO Holder down
slightly, then using your thumb and index finger, gently pull it out and away until if fully clears the
GOBO Wheel.
Locate the tab of the retaining spring. Using a precision
pick (or similar tool), carefully press the retaining spring
inward to relieve the tension. Remove the retaining spring
and carefully separate the GOBO from the GOBO Holder.
Lastly, remove the flat washer attached to the removed
GOBO and attach it to the desired replacement GOBO.
Install the replacement Static GOBO following the steps
above in reverse
1 4
Advertisement
Table of Contents
