Advertisement
Step 13:
Swing beam receiver properly fastened.
Step 15:
Identify end post braces. Fasten the short angle to the
ground runner that was installed on previous step.
Use 4 /18" bolts provided.
26
Swing Frame Assembly
Step 14:
Identify ground runner and fasten to end post using
6 1/2" bolts. Thread acorn nut onto rod as far as you can,
then back off several turns. Be sure to place washer
between acorn nut and vinyl.
Step 16:
Align brace with end post then fasten long angle to end
post using 3/8" x 4" lags provided. This should be pre-
drilled using 1/4" drill bit.
Advertisement
