Advertisement
Step 1:
You are now ready to assemble the swing frame. Begin
by identifying the swing beam.
The end of the beam without caps gets fastened to the
tower.
Step 3:
If you purchased a plastic glider, your next step is to
install the glider bracket. This bracket needs to be
fastened to the opposite side of the swing beam as the
swing bearings. It can be placed at any swing position.
Swing Frame Assembly
Step 2:
Fasten swing bearings to swing beam using lags
provided in bearing packs.
Step 4:
Pre-drill four 1/2" holes, then fasten using four lag
screws provided.
23
Advertisement
