Advertisement
Step 5:
Finish fastening using the 1 3/4" washer head screws
provided.
Step 7:
With swing beam in same position, attach beam strap to
swing beam using two 4 7/8" bolts provided. Only
finger tighten at this point. Note that this end of the
beam should have caps on it. This bracket is fastened
36" from the end of the 14' beam. Use pre-drilled holes.
24
Swing Frame Assembly
Step 6:
Rotate the swing beam 180 degrees so that the swing
bearings are turned up. Fasten the swing beam receiver
bracket to the swing beam using two 4 7/8" bolts
provided. This bracket needs to be fastened to the end of
the swing beam without the caps. Thread acorn nut onto
bolt as far as you can, then back off several turns. Use
washers between the acorn nut and the metal bracket.
Tighten nuts.
Step 8:
Identify end post and place between beam strap. Fasten
using two 4 7/8" bolts provided. You are now ready to
tighten all four bolts on beam strap.
If your setup location is level, the end post will need to
be shortened approximately 1' (cut off bottom end).
Advertisement
