Table of Contents
Advertisement
4 - Check if there is a closed valve on the supply system.
For example, fuel supply valve, condensate tank filling installation, pump supply installation.
Before starting the steam generator, check that the valves on the device are in operational condition. First, the fuel
valve must be opened. Valves on the installation that supply water to the condensate tank should be opened. It should
be checked whether the valve on the line supplying the feed water pumps from the condensate tank is open. In
addition, valves outside the steam generator in the boiler room must be reviewed.
5 - Check the feed pump connections (oil, water) for leaks.
Check that there is no leakage from
the pump, such as water, oil, etc. on
the base where the feed water pump
(Speck) is located. This control before
you start the device will allow you to
detect a problem that may have
occurred in your pump before it
grows much further. (Figure 6)
Figure 6
27
Advertisement
Table of Contents
