Table of Contents
Advertisement
S
3.
Plug
the
shore
power cord into the
shore power outlet
box on the dock and
turn
the
circuit
breaker on the dock
to the ON position.
4.
Check the POWER
light on the main
distribution panel.
The POWER light
should be on and
meter should be
registering proper
voltage. If not have
the dockmaster check the dockside power.
5.
Turn ON the AC main shore power breaker.
Individual AC breakers and switches can now
be energized.
T
:
O USE THE GENERATOR
1.
Start the generator by following the generator start-
up procedures in Section 3 - Using Your Boat , page
3.8 or in your generator owner's manual.
2.
Make sure the shore power breakers and all
AC branch breakers on the AC main distribution
panel are OFF.
3.
Slide the source selector to the right to expose
the two (2) breakers marked GENERATOR.
Push up on the two breakers to energize the
240 volt side of the AC MDP.
®
(525 Sundancer
52 Sundancer
6 • E
ECTION
(F
. 6.19.1)
IG
(F
. 6.19.2)
IG
SHORE POWER LIGHT
100
200
100
200
0
300
0
300
GENERATOR
SHORE
®
)
S
LECTRICAL
F. S
P
HORE
OWER
The 220 volt main distribution panel distributes the
required voltage for all the boat's AC equipment and
accessories. It is important to know and understand
where the power originates and how the power is
distributed to the LINE 1 and LINE 2 equipment and
accessories.
Your 52 DA is equipped with 220 volt AC service.
There are two (2) shore power cables. Both are for
220 volt AC power.
By looking at the AC main distribution panel (AC
MDP), notice there is a LINE 1 and LINE 2 side for
equipment and accessories.
It is imperative that the shore power outlet is dry
before plugging into the dock power inlet.
Shore power cord should be secured or routed to
avoid laying or falling into water and to avoid stress
on shore power plug and inlet.
Do not energize main breaker under reversed
polarity conditions.
1.
Make sure the LINE 1 MAIN shore power
breaker and all LINE 1 AC branch breakers
on the main AC distribution panel are OFF.
2.
Advance shore power LINE 1 cord to dockside
power box. Ensure dockside breaker is OFF,
then plug the dockside cord into the shore
power outlet box on the dock. Turn the circuit
breaker on the dock to the ON position.
3.
Check the LINE 1 POWER lights on the main
distribution panel. The POWER lights should
be on. If the POWER lights are off, check
shore main breaker (Fig. 6.18.1). If breaker
is on, have the dockmaster check the dockside
power connection.
YSTEM
H
(I
'
.)
OOKUP
NT
L
!
CAUTION
!
CAUTION
!
CAUTION
6.19
Advertisement
Table of Contents
