Main Shore Power Breaker Box; Shore Power Hookup (U.s.) - Sea Ray 52 Sundancer Owner's Manual

S
D. M S P
AIN HORE OWER
The 52 DA is equipped with a 240VAC main shore
power breaker box (Figure 6.18.1). The main
breaker box is located on the aft port side of the
engine room (See figure 4.17.1).
The breaker(s) must be ON at all times to operate
the shore AC power system.
M S P B
AIN HORE OWER
(F . 6.18.1)
IG
240VAC
SHORE MAIN
E. S P H
HORE OWER OOKUP
Your 52 DA 240/120 volt AC main distribution panel
distributes the required voltage for all the boat's AC
equipment and accessories. It is very important to
know and understand where the power originates
and how the power is distributed to the different
voltage equipment and accessories.
To access the shore power cable(s), become
familiar with the instructions in Section 3 - Using
Your Boat , page 3.12 for "Cablemaster With
Remote," then follow these steps:
6.18
6 • E
ECTION
B B
REAKER OX
B
REAKER OXES
(U.S.)
S
LECTRICAL
1. Make sure the shore
power breaker and
all AC
breakers on the AC
main distribution
panel are OFF.
Under no circumstances override the source
select system.
2. Advance
power cord(s) to
dockside power box.
Ensure dockside
breaker is OFF, then
plug the shore power
cord(s) into
shore power outlet
box on the dock.
Thread the locking ring on the outlet to secure
cable and prevent accidental unplugging.
The use of extension shore power cords is not
recommended. Excessive power cord extensions
can cause a voltage drop and may prevent some
electronic devices from operating correctly.
Shore power cord should be secured or routed to
avoid laying or falling into water and to avoid stress
on shore power plug and inlet.
It is imperative that the shore power outlet is dry
before plugging into the dock power inlet.
YSTEM
(F . 6.18.2)
IG
branch
GENERATOR
! WARNING
shore
(F . 6.18.3)
IG
the
! CAUTION
! CAUTION
! CAUTION
® (525 Sundancer
52 Sundancer
SHORE
® )