Maintenance For Shore Power Cable And Shore Power Inlet; Battery Charger/Converter (Only With Shore Power Option) - Sea Ray 250 Select EX Owner's Manual

S
C. On the dock, turn
OFF the dockside
breaker.
D. Disconnect the
dockside end of
the power cord.
E. On your boat,
disconnect the
p o w e r c o r d
from your boat
receptacle.
F. Clean the power cord, spray the cord ends with
moisture repellent, and store the cord in a dry
location on board.
You must keep the shore power cord and the plug
ends clean and dry. This is especially necessary if
your boat is used in salt water. Always clean and
spray your cord ends with moisture repellent before
using and before storing the cord.
C. M
AINTENANCE FOR
S P
AND HORE OWER
! WARNING
Disconnect the power cable from power source before
performing maintenance.
The metallic parts of your cable and inlet are made
to resist corrosion. In salt water environment, life
of the product can be increased by periodically
wiping the exposed parts with fresh water, drying
and spraying with a moisture repellent.
250 Select EX
6 • E
ECTION
D P B
OCK OWER OX
(F . 6.7.1)
IG
C
D
S P R
HORE OWER ECEPTACLE
(F . 6.7.2)
IG
E
S P C
HORE OWER ABLE
I
NLET
S
LECTRICAL
A soiled cable can be cleaned with grease-cutting
household detergent. A periodic application of vinyl
protector will help both ends and cable maintain their
original appearance.
In case of salt water spray or immersion: Rinse
plug end and/or connector end thoroughly in fresh
water, shake or blow out excess water and allow to
dry. Spray with a moisture repellent before reuse.
9. S
ERVICING THE
P
ANEL
NOTE: Servicing should be referred to a qualifi ed
electrician.
Disconnect the power cable from power source before
performing maintenance.
T R
O EPLACE A
M D
AIN ISTRIBUTION
1. Turn all breakers OFF.
2. Unplug the shore power.
3. Remove screws from all sides except the
hinged side of panel. The main distribution
panel is hinged to swing open for servicing.
4. Reverse the procedure for closing the panel.
10. B
ATTERY
(O W
NLY ITH
The battery charging unit located on the bilge
component board is fully automatic and is designed
specifi cally for the marine environment. The high
frequency characteristic has allowed these chargers
to achieve a huge size and weight reduction over
their previously used equipment. Commonly called
high frequency or smart chargers, these units bring
a new sophistication to the battery charger fi eld.
YSTEM
M D
AIN ISTRIBUTION
! WARNING
F C
AULTY OMPONENT ON THE
P :
ANEL
C /C
HARGER ONVERTER
S P O
HORE OWER
)
PTION
6.7