Table of Contents
Advertisement
C. On the dock, turn
OFF the dockside
breaker.
D. Disconnect the
dockside end of
the power cord.
E. On your boat,
disconnect the
p o w e r
c o r d
from your boat
receptacle.
F. Clean the power cord, spray the cord ends with
moisture repellent, and store the cord in a dry
location on board.
You must keep the shore power cord and the plug
ends clean and dry. This is especially necessary if
your boat is used in salt water. Always clean and
spray your cord ends with moisture repellent before
using and before storing the cord.
C. M
AINTENANCE FOR
S
P
AND
HORE
OWER
!
WARNING
Disconnect the power cable from power source before
performing maintenance.
The metallic parts of your cable and inlet are made
to resist corrosion. In salt water environment, life
of the product can be increased by periodically
wiping the exposed parts with fresh water, drying
and spraying with a moisture repellent.
3.10
S
3 • U
ECTION
D
P
B
OCK
OWER
OX
(F
. 3.10.1)
IG
C
D
S
P
R
HORE
OWER
ECEPTACLE
(F
. 3.10.2)
IG
E
S
P
C
HORE
OWER
ABLE
I
NLET
Y
B
SING
OUR
A soiled cable can be cleaned with grease-cutting
household detergent. A periodic application of vinyl
protector will help both ends and cable maintain their
original appearance.
In case of salt water spray or immersion: Rinse
plug end and/or connector end thoroughly in fresh
water, shake or blow out excess water and allow to
dry. Spray with a moisture repellent before reuse.
OAT
290 Sundancer
®
Advertisement
Table of Contents
