Teknik 5401562 Instruction Booklet page 7

Step 3
Fasten seven ANGLE BRACKETS (DD) to the ENDS (A
å
and B) and UPRIGHT (C). Use seven BLACK 9/16" LARGE
HEAD SCREWS (TT).
NOTE: Be sure the edges of the ANGLE BRACKETS are
å
even with the edges of the ENDS and UPRIGHT.
Fasten the END MOLDING (Q) to the LEFT END (B). Use
å
three BLACK 9/16" LARGE HEAD SCREWS (TT).
NOTE: There are no pre-drilled holes in the END
å
MOLDING (Q). Turn the screws into the groove of the END
MOLDING. Do not over tighten.
(7 used)
DD
Groove
BLACK 9/16" LARGE HEAD SCREW
Q
B
TT
(10 used in this step)
C
A
DD
Page 7