Technical Data; Remote Control Logic - socomec ATyS Instruction Manual

8.2.2.2. Technical data

Input Qty
DirectCurrentIin
Line resistance
Line length
Pulse duration
Power per Input
Surgeprotection Vin_sg
 E SDwithstandvoltage(Contact/air)
Insulation(Commonmode)
Terminal connector

8.2.2.3. Remote control logic

RemoteswitchingoperationcanbedriveninAUTmodebyexternalvoltfreecontactsasdescribedaboveusinginput
contacts 312 to 317.
DependingonthewiringconfigurationtherearetwotypesoflogicthatmaybeappliedtotheATyS r.
• Impulse logic or
• Contactor logic.
In remote control, the ATyS rinputsgiveprioritytoordersIandIIover0thereforecontactorlogiccanbeimplementedby
simply bridging terminals 316 and 317.
(NOTE:312–317closed/ForceATyS rtoOFFPosition,takespriorityoverallotherordersnomatterofthecontrollogic
used.)
Impulselogic:
The ATyS risdriventoastableposition(I–O–II)afterreceiving
an impulse order.
• A switching command of at least 60 ms is necessary to
initiate the switching operation.
• Orders I and II have priority over order 0.
Note:Thelogicdiagramsexcludethetransfertimes.
ContactorLogic :
The ATyS risdriventoaspecificposition(IorII)foraslongas
the order is maintained.
• OrderOismaintained.(Bridge316–317)
• Orders I and II have priority over order 0.
• Orders I and II have equal priority.
(1st order received is held until no longer maintained).
• If order I or II disappears, the device returns to zero position.
(With the power supply available).
38
EN
MOTORISATION MODULE
5
0.35 to 0.5mA
1kΩ
100m(Min.wire1.5mm²#16AWG)
60ms
0.06VA
4.8kV(1.2/50µssurge)
2/4kV
4.8kVAC
(BetweenI/Pandallcommonparts)
1.5mm²minimum/2.5mm²max
Impulse logic
order I
order 0
order II
position I
position 0
position II
Imp.≥60ms
(Note :Excludespositionswitchingdelays)
Contactor logic
order I
order 0
order II
position I
position 0
position II
maintened
(Note :Excludespositionswitchingdelays)
ATyS / ATyS r - 541630C - SOCOMEC