Infrared Detector; General; Procedure - FLIR T6 Series User Manual

Hide thumbs Also See for T6 Series:

Table of Contents

Find Quality Products Online at:

Cleaning the camera

26.3 Infrared detector

Even small amounts of dust on the infrared detector can result in major blemishes in the

image. To remove any dust from the detector, follow the procedure below.

Note

• This section only applies to cameras where removing the lens exposes the infrared

detector.

• In some cases the dust cannot be removed by following this procedure: the infrared

detector must be cleaned mechanically. This mechanical cleaning must be carried out

by an authorized service partner.

CAUTION

In Step 2 below, do not use pressurized air from pneumatic air circuits in a workshop, etc., as this air

usually contains oil mist to lubricate pneumatic tools.

Follow this procedure:

1. Remove the lens from the camera.

2. Use pressurized air from a compressed air canister to blow off the dust.

GlobalTestSupply

www.

#T559880; r. AM/56659/56659; en-US

.com

sales@GlobalTestSupply.com

Table of Contents