Fetching Data From External Flir Meters; General; Supported Flir Meters; Technical Support For External Meters - FLIR T6 Series User Manual

17
Find Quality Products Online at:
Fetching data from external FLIR
meters

17.1 General

You can fetch data from an external FLIR meter and merge this data into the infrared
image.
When the camera is connected to a FLIR meter via Bluetooth, the measurement value
from the meter is displayed in the result table of the camera. The FLIR meter value is also
added to the information saved in the image file. In preview mode and when editing an
image in the archive, you can add more than one value from the same FLIR meter.
Note
• Before you can use a FLIR meter with the camera, you need to pair the devices. For
more information, see 11 Pairing Bluetooth devices, page 21.
• To add more than one FLIR meter value when saving an image, preview mode must
be enabled. Select
On.
In preview mode and when editing an image in the archive, you can do the following:
• Push the programmable button
meter.
• Push and hold the programmable button
image.
Note Any function assigned to the programmable button is temporarily disabled when
in preview mode or when editing an image in the archive.

17.2 Supported FLIR meters

• FLIR CM78
• FLIR CM83
• FLIR DM93
• FLIR MR77

17.3 Technical support for external meters

Technical support
Website
E-mail
Phone
Repairs
17.4 Typical moisture measurement and
documentation procedure
17.4.1 General
The following procedure can form the basis for other procedures using FLIR meters and
infrared cameras.
GlobalTestSupply
www.
#T559880; r. AM/56659/56659; en-US
(Settings) > Save options > Preview image before saving =
to add the value currently displayed by the FLIR
to remove all FLIR meter values from the
http://support.flir.com
TMsupport@flir.com
855-499-3662
repair@flir.com
.com
sales@GlobalTestSupply.com
50