Table of Contents
Advertisement
operation.
• Make sure that the power supply is off and that the power cord is disconnected
before servicing. Allow at least 5 minutes for the device to cool down after
unplugging it before reaching inside to service.
• Always turn off the printer and disconnect from the computer when it is not being
used.
• Make sure to level the build plate properly before use.
• Make sure not to force anything, whether it be during unpacking, setup, operation
or service.
• Service and oil the suggested parts as often as recommended. Only use only
substances recommended by CraftUnique.
• The CraftBot 3D printer melts plastic during printing. Plastic odors/gases are
emitted during this operation. Make sure to set up the CraftBot 3D printer in a
well-ventilated area.
6
Advertisement
Table of Contents
Need help?
Do you have a question about the CB4 FLOW Series and is the answer not in the manual?
Questions and answers