CraftBot CB4 FLOW Series User Manual page 34

overspray. Make sure the lubricant reaches the inside of every thread (if
using grease, spread with hand wearing gloves).
7. Make sure not to overlubricate, spray only the minimum required
amount!
8. Do not spray the other two rods directly! Spray the towels and wipe it
onto the rods.
9. Remove the rag from the CraftBot interior.
10. Plug in and power up the CraftBot and move the build plate to the lowest
point ("Axes" menu, home position and then go to the directional menu
and press the Z down arrow until the bed reaches the lowest point).
11. Turn the CraftBot printer off and unplug it from the electrical outlet.
12. Place a second clean rag on top of the heated build plate to protect the
components and Kapton from any overspray.
13. Repeat the process for the top side of the Z-axis rods the same as you
performed on the bottom side: protective rag behind threaded rod,
spray, wipe excess lubricant on other two outside rods.
14. Power up the CraftBot once again and raise the build plate back up to the
highest position (set the X, Y and Z to the home position).
15. Turn the CraftBot printer off and unplug it from the electrical outlet.
16. Wipe any excess lubricant off from the bottom side of the Z-axis rods.
17. Power up your CraftBot once again and move the build plate back to the
lowest point.
18. Turn the CraftBot printer off and unplug it from the electrical outlet.
19. Wipe any excess lubricant off from the top side of the Z-axis rods.
20. Power up the CraftBot once again and raise the build plate back up to the
highest position.
21. Turn the CraftBot printer off and unplug it from the electrical outlet. The
motors will now disengage so that you can move the extruder freely by
hand.
22. Use an oiled rag to lubricate the X and Y linear rails. Do not spray from
above! Move the extruders back and forth by hand to both extremes of
the axes. When the extruders move absolutely smoothly you are
finished.
34