Table of Contents
Advertisement
Section
4
1. Plumbing
1.1. The 15 mm inlet compression connector incorporates an inlet filter, which
swivels to allow three entry positions, top, back and bottom inlet.
1.2. The outlet terminates with a 1/2" BSP male thread for connection to a Mira
flexible shower hose.
1.3. The appliance is designed to operate with a minimum inlet head of 80
millimetres up to a maximum inlet head of 10 metres (i.e. the vertical
distance from the base of the cold cistern to the top of the appliance).
2. electrical
2.1. The terminal block will not accept cable larger than 10 mm
2.2. Pump duty cycle: 25%: 15 minutes on, 45 minutes off.
2.3. The motor is fitted with a self resetting thermal trip protection device,
designed to operate if the duty cycle is exceeded or the ambient
temperatures become too high. The maximum recommended ambient
temperature for the appliance is 30°C.
2.4. The following power ratings for the heater tanks are available with their
respective voltages:
2.5. The motor will absorb approximately 100 Watts maximum power under
normal working conditions.
3. standards and approvals
3.1. All materials in contact with water are Water Bye-laws Scheme (WBS)
approved.
3.2. When installed correctly, the appliance complies with the requirements
of BS 7671 "Requirements for Electrical Installations" (IEE Wiring
Regulations).
3.3. The appliance has been designed to comply with the requirements of
BS 3456 "Specification for Household and Similar Electrical Appliances",
Part 3, Section 3.9: 1979.
3.4. British Electrotechnical Approvals Board (BEAB) and WBS approval
pending.
3.5. This appliance complies with the electromagnetic compatibility (EMC)
directive EN50082-1 (1992), EN55022 (1987) and EN60555-2/3 (1987).
Please see carton for CE approval label.
Specifications
Mira Elite 8.5 240V 36 Amps
Mira Elite 8.5 230V 38 Amps
.
2
9
Advertisement
Table of Contents
