Table of Contents
Advertisement
1.15. Refit the case insert and ensure
that the earth bonding wire to the
inlet connector is tight.
Finally re-tighten the screws of
the terminal block.
1.16. Refit the cover by locating the top
of the cover onto the spigot on the
top of the case. Push the bottom
of the cover against the case and
tighten the captive cover retaining
screw.
2. Shower fittings
Read the section "important safety information" first
2.1. To install the shower fittings, please refer to the appropriate section in the
Installation, Operation and Maintenance Guide which accompanies the
fittings.
2.2. The high capacity spray plate illustrated in the guide is not supplied with this
appliance.
20
Advertisement
Table of Contents
