Table of Contents
Advertisement
2. Appliance
Read the section "important safety information" first.
The sPraY PlaTe holes MusT be KePT clear. The spray plate should be
regularly removed and cleaned in descalent. Lack of regular spray plate cleaning will
lead to poor performance and cause early failure of the appliance.
Temperature and Flow Control
High
Low
Cool
Power Control
2.1. Switch on pullcord or wall mounted
switch. The "Power" light on
the appliance will provide a visual
indication that the switch is on.
2.2. Rotate the left-hand control knob
to position "hiGh" (full power).
2.3. Wait 15–20 seconds for warm
water to reach the handset.
2.4. If necessary turn the right-hand
control knob slowly to adjust
temperature. Allow 10–15 seconds
for the adjusted temperature
to reach the handset. The
control knob operates through
approximately 3/4" of a turn from
cold to hot.
Clockwise - WARMER - less flow
Anticlockwise - COOLER - more
flow
note! The tone of the pump motor
may change when the temperature
control knob is adjusted. This is
quite normal
2.5. To Turn off turn the left control
knob anticlockwise to "sToP"
position.
(For summer economy showering
use position "low" (half power)
on the control. For a cold shower
select "cool".
2.6. Switch off pullcord or wall mounted
switch.
25
Advertisement
Table of Contents
