Table of Contents
Advertisement
3.2 Installation
3.2.2 Installing and Removing the SC-HG1-ETC and Compatible Devices
● Do not pull the connector or cable forcefully. Doing so may damage the connector or
break the wires.
● Do not use any tools (such as pliers) to pull out the connector.
● Firmly hold the connector when performing wiring work. Do not forcibly push wires into
the connector. Doing so may result in injury.
● Do not reuse any connectors that have been wire-pressed once. The performance of re-
used wire-pressed connectors cannot be guaranteed.
● Before wiring work, always turn OFF the master controller.
● To connect units, always mount them on a DIN rail. When doing this, mount end plates
MS-DIN-E (optional) so as to enclose the connected units at both ends.
■ How to connect
1.
Mount this product on a 35-mm-wide DIN rail.
2.
Remove the connector cover from the controller. (Note 1)
Controller - Slave unit (Option)
SC-HG1-ETC
Note : Keep the connector cover removed from the controller in a safe place.
3.
Slide this product until it directly contacts the controller.
3-4
Connector cover
Slide
Controller - Master unit (Option)
WUME-SCHG1ETC-2
Advertisement
Table of Contents
