Panasonic SC-HG1-ETC User Manual page 55

Command
0x00A3 to 0x00FF
0x0100 to 0x0112
0x0113 to 0x02FF
0x0300
0x0301 to 0x0303
0x0304
0x0305
0x0306
0x0307
0x0308
0x0309
0x030A to 0x030B
0x030C
0x030D
0x030E
0x030F to 0x0315
0x0316
0x0300
0x0301 to 0x0303
0x0304
0x0305
0x0306
0x0307
0x0308
WUME-SCHG1ETC-2
Attribute Name
‒ System reserved
‒ Other model command area
‒ System reserved
R/W Operation mode (OP.MODE)
- System reserved
R/W Sensitivity setting (SEN.ADJ)
R/W Judgment level (JDG.LVL)
R/W Judgment filter (JDG.FIL)
Reference waveform save
R/W
(BW.SAVE)
Interference prevention func-
R/W
tion (INTF.PR)
Alarm state selection
R/W
(ALM.CND)
- System reserved
R/W Stain check (STA.CHK)
R/W Stain threshold (STA.THR)
R/W Hold setting (HOLD)
- System reserved
Calculation mode (MODE) /
R/W Calculation application selec-
tion (APPLI)
R/W Operation mode (OP.MODE)
- System reserved
R/W Sensitivity setting (SEN.ADJ)
R/W Judgment level (JDG.LVL)
R/W Judgment filter (JDG.FIL)
Reference waveform save
R/W
(BW.SAVE)
Interference prevention func-
R/W
tion (INTF.PR)
4.4 Command List
Response/Setting parameter
Do not use.
Do not use.
Do not use.
0: Auto edge detection mode
1: Edge detection mode
2: External form/width detection mode
3: Inside diameter/gap detection mode
5: Center position detection mode
Do not use.
0: DEFAULT
1: USER
10 to 90
3 to 50
0: OFF
1: ON
0: OFF
1: ON
0: HOLD (hold previous value)
1: ALARM (alarm output)
Do not use.
0: Stain check OFF (OFF)
1: Low sensitivity setting ON (LOW)
2: High sensitivity setting ON (HIGH)
3: User setting ON (USER)
50 to 95
Set the sum of the values below according to
the states of the measurement mode and trigger
mode settings.
• Measurement mode (MEAS)
0x0000 = Sample hold
0x1000 = Peak hold
0x2000 = Bottom hold
0x3000 = Peak to peak hold
0x4000 = Peak to peak hold P-P/2
0x5000 = NG hold
• Trigger mode (TRIG)
0x000 = One-shot
0x100 = Hold
Do not use.
0: No calculation
1: Maximum value (MAX)
2: Minimum value (MIN)
4: Average value (AVERAG)
5: Standard difference (STAND)
8: Thickness/Width (THICK)
0: Auto edge detection mode
1: Edge detection mode
2: External form/width detection mode
3: Inside diameter/gap detection mode
5: Center position detection mode
Do not use.
0: DEFAULT
1: USER
10 to 90
3 to 50
0: OFF
1: ON
0: OFF
1: ON
4-25