Panasonic SC-HG1-ETC User Manual page 17

Information
● If HG-SC series and HG-TC series controllers are used in combination, connect the slave con-
trollers of the same series as the master controller on the near side of the master controller and
connect the slave controllers of different series from the master controller on the far side of the
master controller.
Example: When the master controller is HG-SC□
SC-HG1-ETC
● If HG-TC series and HG-SC series controllers are used in combination, there are limitations on
the functions below.
Item
Calculation
1
function
2 Input all
3 Copy function
Interference
4
prevention
WUME-SCHG1ETC-2
2.1 System Configuration of This Product
Controller - Master unit
HG-SC□
Controller - Slave unit
HG-SC□
Controller - Slave unit
HG-TC□
Calculation is only performed when the slave unit is the same series as the
master unit.
Calculation is not performed when the slave unit series is different from the
master unit series. "CALC" does not appear in the display of a slave unit of a
different series.
The master unit only performs input all when the slave units are the same
series.
A slave unit of a different series from the master unit does not perform input
even when the external input settings match those of the master unit.
Copying is only performed when the slave unit is the same series as the mas-
ter unit.
When copying is executed, "NOW COPY" appears even on the display of a
slave unit of a different series from the master unit , but copying is not per-
formed.
This function is only available on the HG-TC series controller. The function is
not executed on the HG-SC series controller.
Description of limitation
2-3