Specifications - Panasonic SC-HG1-ETC User Manual

6.1. Specifications

6.1. Specifications
Product name
Model
Power supply voltage (Note 1)
Current consumption
Communication protocol
Compliance
Communication speed
Telecommunications connector
Node-to-node distance
Compatible controllers
Maximum number of sensor units
that can be connected
Supported functions
Ambient temperature
Ambient humidity
Operating altitude (Note 2)
Contamination level
Withstand voltage
Insulation resistance
Vibration resistance
Shock resistance
Telecommunications cable
Grounding method
Material
Weight (main unit only)
Standards compliance
Notes: 1) Electric power required for this product is supplied from the controller (master unit or slave unit) con-
nected to it.
2) Do not use or store this product in environments where ambient air is pressurized to an air pressure
higher than the atmospheric pressure at an altitude of 0 m.
6-2
EtherCAT-compatible Communication Unit for HG Series
24 VDC ±10%, including 0.5 V ripple (P-P)
Up to 15 controllers (1 master controller and 14 slave controllers) can be
connected to a single SC-HG1-ETC communication unit.
Process data object communication (cyclic communication)
Mailbox communication (message communication) CoE
-10 to +45ºC (No condensation or icing), Storage: -20 to +60ºC
35% to 85% RH, Storage: 35% to 85% RH
1,000 VAC for one minute between all supply terminals and case
20 MΩ or higher, using 250 VDC megohmmeter connected between all
10 to 150 Hz with 0.75 mm amplitude (10 to 58 Hz) at acceleration of 49 m/s
(58 to 150 Hz) in X, Y, and Z directions for two hours each
98 m/s 2 (approx. 10G) 5 times each in X, Y, and Z directions
Category 5e (shielded twisted pair cable recommended)
SC-HG1-ETC
100 mA or less
EtherCAT
IEEE802.3u(100BASE-TX)
100Mbps(100BASE-TX)
RJ-45×2
100 m or less
HG-SC□, HG-TC□
Explicit Device ID
Station aliases supported
2,000 m or less
2
supply terminals and case
Casing: Floating type
Case: Polycarbonate
Approx. 90 g
European Standards (EN)
2
WUME-SCHG1ETC-2