Function Setting; Description Of Parameter Values - Jadever JWI-3100 User Manual

ZERO/ESC
Press
CAN DIEN TU TAN HIEP THANH
0.02 KG" 0.02 KG
0.02 KG 0.02 KG
"
Note : LONG press
+/PRINT/HI
3. Press
TARE/
or to shift the decimal point
Note: if not the needed division, long press
to set the division casually. Please do as follows.
/G/N
Press
+/PRINT/HI
Press
/G/N
Press
+/PRINT/HI
Press
ZERO/ESC
Press
4. The window dispays CAL. Press
ZERO/ESC
to exit and return to weighing mode.

5-2 Function Setting

UNIT/SET
1. Press and hold
weighing mode to enter function setting.
/G/N TARE/
2. Press or
UNIT/SET
3. Press
/G/N TARE/
4. Press or
ZERO/ESC
5. Press
to exit without saving and return to the previous parameter.
ZERO/ESC
6. Press
5-3

Description of Parameter Values

1. Offset value
www.tanhiepthanh.com.vn
to save and entet into division setting when the window dispays
ZERO/ESC
is to return to weighing mode without saving.
HOLD/LO/- to choose common used division.
or
TARE/
or to shift key leftward or rightward
-/ HOLD/LO
or
TARE/
or until the decimal point is blinking.
-/ HOLD/LO
or
to save and enter into calibration setting.
TARE/
while powering on or long press
to shift between the functions
to enter the parameter setting.
to shift between the function parameters
to save and return to the previous parameter or long press
and return to normal weighing mode.
UNIT/SET
until the number rightmost is blinking
to change the value.
to shift the decimal point
to enter calibration setting while LONG press
JWI-3000
Press
UNIT/SET
under normal
ZERO/ESC
7
/G/N