Operation; Weighing; Tare - Jadever JWI-3100 User Manual

If you need to change the value, do as the following: Press
CAN DIEN TU TAN HIEP THANH
/G/N
setting. Press
HOLD/LO/-
to change the value. Press
4. Put the corresponding weight on the weighing pan and then press
first point calibration.
Note: After the first point calibration, the window can display the weight value. If no need for
the other point calibration, move to Step 6 to finish the calibration procedure.
5. Add another weight to the current weight. The window will show the total weights value.

TARE/

Press
ZERO/ESC
6. Press
weighing mode.

7. Operation

7-1 Weighing

Begin with no load on the scale, the display reading zero. Place item(s) to be weighed on the
scale. The display shown is 1.000kg, gross weight.
selected before weighing, refer to section 5-5.
→
7-2 Manual Tare & Preset Tare
When weighing a sample that must be held in a container, tare stores the container weight into
memory.
1) Under the weighing mode, place the container on the weighing pan, wait till stable
symbol appears, then press the key
→
Place the item(s) to be weighed into the container. The weight displayed is the net weight.
2)
www.tanhiepthanh.com.vn
TARE/
or to move leftwards or rightwards. Press
to complete. Repeat this step to complete multi-point calibration.
to save. After the window displays "
TARE/
UNIT/SET
ZERO/ESC
to save.
T he desired weighing unit should be
（
）
The container is tared.
.
JWI-3000
to enter the value
+/PRINT/HI
TARE/
to complete the
", it will return to normal
11
or