Operation; Weighing; Manual Tare &Preset Tare - Jadever JWL Series Manual

4. Put the corresponding weight on the weighing pan, and then press
point calibration. "
Note: After the first point calibration, the window can display the weight value. If no need for
the other point calibration, move to step 6 to finish the calibration procedure.
5. Add another mass to the current weight. The window will show the total weight. Press
to complete. "
M+/SAVE
6. Press
mode.

7. Operation

7-1 Weighing

Begin with no load on the scale, the display reading zero. Place item(s) to be weighed on the scale.
The display shown is 1000.0g, gross weight.（The desired weighing unit should be selected before
weighing, refer to section 7-5.）
→
7-2 Manual Tare & Preset Tare
When weighing a sample that must be held in a container, tare stores the container weight into
memory.
Manual Tare
1) Under the weighing mode, place the container on the weighing pan, wait till stable
symbol appears, and press the key
→
2) Place the item(s) to be weighed into the container. The weight displayed is the net weight.
3) Remove all items from the weighing pan; the screen displays the tare value.
4) To clear tare with an empty pan, Press down key
Preset Tare
1) Long press key
left-most digit blinking.
/MR or TARE/
2) Press
"appears at the left bottom.
"appears at the left bottom.
to save. After the window displays "
TARE
TARE
for 3 seconds. The scale is now in Digital inputting mode with the
to move leftwards or rightwards. Press
(II)
. The container is tared.
TARE
or key
JWL
TARE
to complete the first
", it will return to normal weighing
ZERO/ESC
.
+/PRINT/HI or
TARE
10