Advertisement
Work table height adjustment
To optimize the use of the press it is necessary to set the work table at a convenient height in
relation to the operation to be carried out and to the equipment to be used.
Before proceeding to lift the mobile table, check that:
-
The eyebolts fixed to the work table are fully tightened Pos. 01.
-
The eyebolt support (nose piece) is properly screwed onto the cylinder ram (Pos. 2)
-
The eyebolts fixed to the nose piece are fully tightened.
1. Hook the chains (Pos. 5) to the respective eyebolts and lift the cylinder ram until the
chains are set under tension but, do not lift the table.
2. Check the chain connections to all eyebolts to ensure a safe secure connection.
3. When the connection is safe, lift the table just above the desired table height.
4. Take the split pins (Pos. 6) off the pins then remove the pins.
5. Insert the pins to the desired work table height pin location then, insert the split pins.
6. Slowly move the table down until it rests on the table pins.
7. Check to be sure the position and the assembly of the pins are correct.
8. Unhook the chains and leave them hang in a downward position (Pos. 5).
Force 40 70 100 150 Ton
Fig. 8
Pos. 2
Pos. 3
Pos. 1
Pos. 5
11
Pos. 6
Advertisement
