Mechanical Brake Release - CombiLift C3000CB Manual

Combilift Ltd

5.4 Mechanical Brake Release

In order to release the brake, follow the steps laid out below.
1. Extract the plug from the rear
cover of the motor. (Labelled
142 in the diagram opposite)
2. Insert a socket head bolt as
shown in the diagram with a
nut fully inserted onto the bolt.
3. Using a spacer similar to the
one shown on the diagram
tighten the bolt into the Brake
assembly at the rear of the
motor
4. When the bolt is in tight, loosen
the nut off the bolt by turning it
anticlockwise as shown. This
action will release the brake
and allow the motor to turn
freely
5. To reapply the brake, repeat
the steps above in reverse
order.
C2500CB-OM-EN-11
C2500-C3000CB O&S Manual
5-4