Combilift Ltd
2.17: Placing a Load When In Sideward Mode
Drive the machine forward as close to the placing area as possible.
Apply parking brake.
Lower/raise the forks to the required height.
Lower load.
Tilt forward.
Release parking brake.
Drive rearward until machine is clear of load
Continue to drive in the sideward direction
When handling long length loads, drive whenever possible in the sideward
mode. Tilt elevated loads forwards, only when directly over load destination
2.18: Placing a Load When In Forward Mode
Drive machine forward as close to the placing area as possible.
Apply parking brake.
Lower/raise the forks to the required height.
Lower load.
Tilt forward.
Drive rearward until machine is clear of load
2.19: Double Forking
If it is not possible to engage forks fully when lifting a load it will be necessary
to move the load closer to the front of the machine before lifting. This can be
achieved by double forking the load.
The lift capacity of the Combilift is reduced if the forks are not fully engaged .
To Double Fork a Load:
Raise the load slightly and drive rearward sufficiently to bring the load
closer to the machine.
Lower the load and drive forward until the load is against the fork face.
The load is now ready to be lifted.
C2500CB-OM-EN-11
C2500-C3000CB O&S Manual
NOTE
NOTE
2-7