Stopping; Loading; When Loading In Sideward Mode; When Loading In Forward Mode - CombiLift C3000CB Manual

Combilift Ltd

2.13: Stopping

 Always brake evenly and smoothly. Violent braking may cause the load to
slip from the forks.
 The forks must be lowered when the truck has stopped.
 After stopping the truck, return the direction control switch to neutral.
 When the operator leaves the forklift truck unattended, the parking brake
must be applied and the ignition key removed to prevent unauthorised use
The brake/inching pedal permits slow drive speed for precise manoeuvring of
the truck in confined spaces. It operates independently of the accelerator
pedal, but if fully depressed stop drive to slow the machine down.

2.14: Loading

 Do not exceed rated capacity of truck. Overloading can cause truck
instability. If in doubt, check with the load chart, located inside the cabin.
 Before picking up a load adjust the forks to ensure that they are equally
spaced about the centre line of the fork carriage and as widely spaced as
possible to take the weight of the load evenly.
 Check that the forks are of sufficient length. The length should be at least
two thirds of the depth (front to back) of the load.
 When manoeuvring to pick up a load, avoid erratic movements that could
result in damage to the load and/or truck.
 Apply parking brake when loading

2.15: When Loading in Sideward Mode

 Move forward as close to the load as possible.
 Manoeuvre the machine so it is at the centre of the load.
 Apply parking brake.
 Lower/raise the forks to the required height.
 Slowly drive forks into the pallet
 Lift load.
 Double fork load if necessary until load is tight against face of forks. (See
section on "double forking")
 Tilt rearward to secure the load.
 Lower forks until load is 150mm (6") above the ground.

2.16: When Loading in Forward Mode

 Lower/raise forks to the required height.
 Manoeuvre the machine forward so it is at the centre of the load.
 Apply parking brake.
 Lift load.
 Tilt rearward to secure load.
 Double fork load if necessary until load is tight against face of forks.
 Lower forks until load is 150mm (6") above the ground.
C2500CB-OM-EN-11
C2500-C3000CB O&S Manual
NOTE
2-6