Combilift Ltd
2.7: Entering and Exiting the Operator Cabin
When entering or exiting the Operator cabin of the Combilift, always use a
three point contact method to avoid slips and falls. The three point contact
method is applied by keeping 3 of the bodies 4 limbs (hands & feet) in
contact with the machine.
Always use the handles and footsteps on the machine.
NEVER use the steering wheel as a handle.
2.8: Starting Procedure
Diesel Engine
Ensure that the parking brake is applied and that the directional control
lever is in the neutral position
Insert the key into the ignition switch and turn clockwise to the preheat
position. The charge indicator lamp must light up.
Depress the accelerator.
Turn the ignition key further clockwise to the "Start" position. After the
engine starts, release the ignition key which will return automatically to
the ON position.
Check that all the indicator lamps are extinguished and that all gauges
are registering correctly.
LP Gas System
Open the valve on the LPG tank.
Ensure that the parking brake is applied and that the directional control
lever is in the neutral position
Insert the key into the ignition switch and turn clockwise to the 'ON'
position. The charge indicator lamp must light up.
Turn the ignition key further clockwise to the 'start' position.
As soon as the engine starts, release the ignition key, which will
automatically return to the 'ON' position.
Check that all warning lamps are extinguished and that all gauges are
registering correctly
The truck will NOT start unless the directional control lever is in the
The starter must not be operated continuously for more than 30
Seconds. If the engine does not start, return key to the "OFF"
When the machine is started the wheels will remain in whatever
Position they were in when the machine was stopped until the
Operator selects a direction of travel on the direction control lever.
C2500CB-OM-EN-11
neutral position.
position and wait 10 seconds before trying again.
C2500-C3000CB O&S Manual
NOTE:
NOTE:
NOTE:
2-4