Initial Service - Conducted At 100 Hours Of Operation; Engine Oil & Engine Oil Filter (Service Interval = 250Hours) - CombiLift C3000CB Manual

Combilift Ltd
Initial Service – Conducted at 100 hours of Operation
4.3:
The initial service is conducted at this interval to ensure that the truck is in
optimum working condition upon leaving the factory. In order to complete the
initial service the following task must be completed.
 Change engine oil & oil filter.
 Replace fuel filter.
 Check fan belt tension and adjust if required.
 Replace hydraulic suction filter (located at rear of hydraulic tank)
 Replace return filter (located on top of the hydraulic tank)
 Check hydraulic oil level.
 Check coolant level.
 Check the machine for hydraulic, coolant and fuel leaks.
 Check air cleaner and replace if necessary.
 Check all mast carriage-bearing lock nuts are tight.
 Check all bolts and fittings are tight.
 Check radiator, and if necessary, clean fins
 Grease all points indicated on grease point chart
 Torque all wheel nuts (210Nm / 155ft-lb)
 Check mast chains; lubricate and adjust if required.
All grease points indicated on the grease point chart MUST be greased
All wheel nuts should be checked daily and torqued every 250 hours to:
Engine Oil & Engine Oil Filter (Service Interval = 250Hours)
4.4:
The engine oil used in the Combilift should have the correct temperature range
for the ambient temperature in which the machine is to be operating.
Temperature affects the viscosity of the oil and therefore it's lubricating
properties. All Combilift trucks leave the factory with a special, high multi-grade
oil in the engine and this can be used all year round except in very cold
climates.
To check the engine oil level:
 Park the truck on level ground, apply the park brake and shut off the
engine.
 Ensure the engine has been stopped for at least 3 minutes.
 Remove the dipstick and wipe it with a clean cloth.
 Fully insert the dipstick and remove it again, check if the oil level is
between the upper and lower marks.
 If the oil is below the lower mark add oil of the same specification at that
already in the engine, to the upper mark.
C2500CB-OM-EN-11
Note
weekly using an appropriate EP2 Grease
Note
(210Nm / 155ft-lb)
C2500-C3000CB O&S Manual
4-7