Hydraulic Oil & Filters - CombiLift C3000CB Manual

Combilift Ltd
4.7: Hydraulic Oil & Filters
The hydraulic oil used in the Combilift should conform to the International
Standard.
characteristics. It should also have the correct temperature range for the
ambient temperature in which the machine is being operated. If the operating
temperature is outside the standard range, the standard oil should be
replaced with the correct grade.
Ensure that the correct type is used in the relevant ambient temperature. The
table below indicates a number of commercially available oils and the
temperature ranges that they are suitable for.
AMBIENT
OPERATING
TEMPERATURE
Castrol: Hyspin
B.P. Bartran
Esso: Univis
Mobil
Shell: Tellus oil
Texaco
The Sequence in which the brand names are listed does not signify any
The machine is supplied with an AWH46 hydraulic fluid when leaving the
factory. Please check if this is suitable for the ambient temperature in which
Before adding hydraulic oil, ensure that all cylinders are retracted and fill to
There are a total of 3 filters on or in the hydraulic oil tank that must be
replaced at certain intervals. These filters are:
1. The Suction Filter
2. The Return Filter
3. The In-Tank Strainer Filter
C2500CB-OM-EN-11
I.S.O. G344 HV grade oils with improved viscosity / temperature
Low Range
-20°C to25°C
-4°F to 77°F
AWH 32
HV 32
N 32
13 M
T32
HDZ 32
grading as to their quality or preference.
the machine is to be operated
upper level on the hydraulic oil level gauge.
Hydraulic Tank Capacity – 39 litres
Hydraulic System Capacity – 52 litres approx.
C2500-C3000CB O&S Manual
Standard Range
-10°C to35°C
14°F to 95°F
AWH 46
HV 46
N 46
15 M
T46
HDZ 46
Note
Note
Note
High Range
0°C to45°C
32°F to 113°F
AWH 68
HV 68
N 68
16 M
T68
HDZ 68
4-10