Installing The Battery - Fluke 80i-110s User Manual

Ac/dc current probe

Hide thumbs Also See for 80i-110s:

Table of Contents

80i-110s Instruction Manual

INSTALLING THE BATTERY

TO AVOID ELECTRICAL SHOCK, UNCLAMP THE CURRENT PROBE FROM

ANY CONDUCTOR, AND DISCONNECT THE SCOPEMETER TEST TOOL OR

ANY OTHER MEASUREMENT DEVICE BEFORE INSTALLING OR REPLACING

THE BATTERY.

At first use, remember to install the battery. Referring to Figure 2, use the following

procedure to install the battery:

1. Be sure that you have unclamped the Current Probe from any conductor and

have disconnected the ScopeMeter test tool or any other measurement device.

2. Be sure that the Current Probe is in the OFF position.

3. Locate the battery cover on the handle. (see Figure 2.) Loosen the screw with

a flat-blade screwdriver.

4. Slide the battery cover away from the Current Probe.

5. Install the battery (IEC 6LR61) as shown in Figure 2. Arrange the battery leads

so that they will not be pinched between the handle bottom and the battery cover.

6. Reinstall the battery cover and secure the screw.

WARNING

Figure 2.

Installing the Battery

Table of Contents

Show Quick Links

Table of Contents