Recharging The Battery - Integra 90520 Operation And Service Manual

Recharging the Battery

1. Place the Battery Charger on a flat, level surface away from
10
sources of heat and moisture.
2. Connect the Battery Charger base to the 60W power supply.
Insert the supplied AC Mains cord into the power supply. Plug
the AC Mains cord into any standard 100 VAC to 240 VAC 47-63
Hz outlet.
11
Note: When using the Dual Bay Battery Charger (Figure 11), a
battery may be placed into either battery bay. Each bay
is completely independent and two batteries may be
charged simultaneously.
3. Place the battery into the Charger's battery bay, ensuring that the
5-pin connector is fully seated (Figure 10).
4. The Battery Charger will automatically begin charging. The
LEDs in the charger status window will provide charging status
information:
Green flashing
Green solid
Red solid
5. A completely discharged battery should become fully charged in
approximately two and one-half (2.5) hours.
6. Each fully charged battery is designed to operate for
approximately 2 hours plus low battery warning cycle on
the high switch setting.
Battery charging
Battery fully charged
Error — replace battery
10
11
12