Setup, Alignment And Test Procedures - Christie GS Series User Manual

Setup, alignment and test procedures

Follow the steps for the initial setup, alignment and test procedures.
1. Ensure all appropriate agencies have been notified.
2. Ensure that all required documentation is present at show site.
3. Hang appropriate laser area warning signage (if applicable).
4. Ensure all laser equipment is securely and rigidly mounted.
5. Ensure all cables are appropriately dressed and covered to prevent tripping or other hazards.
6. Perform visual inspection of projector for damage and other issues.
7. Notify and remove all non-essential personnel from fixed radiation area.
8. Check operation of safety features such as, shutters and labels.
9. Check all radiation areas for safe emission condition to ensure no people or objects are
obstructing the beam path.
10. Power on lasers.
11. Open shutter and ensure proper operation of laser projector.
12. Use and fill-in Checklist for laser install.
13. Evaluate, discuss and address possible safety concerns.
14. Power off lasers.
15. Ensure operating procedures and checklists are current
GS Series DWU1082-GS User Manual
020-001800-01 Rev. 1 (04-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
Installation
26