Table of Contents
Advertisement
4. From the RAID controller that has failed, remove the Fibre Channel cables from
the GBICs. The location of these components is shown in the following
illustration.
Fiber-optic
cable
After removing the Fibre Channel cables, insert the protective caps.
5. Use the following procedure to remove the GBICs from the RAID controller that
has failed.
a. Move the metal latch on the GBIC to the unlocked (center) position.
b. Pull the GBIC out of the port.
c. Insert the protective cap on the GBIC.
GBIC
Raid controller
Chapter 5. Installing and replacing components
55
Advertisement
Table of Contents
Need help?
Do you have a question about the FAStT200 and is the answer not in the manual?