Advertisement
DURACRYL WALL
DURACRYL WALL INSTALLATION CONT...
To install the wall follow the approved
adhesive manufacturer instructions.
As a general rule, place wall into position (check
shelves fit correctly for moulded corner models).
Press firmly back into the corner to ensure that
the wall makes full contact with the corner along
its entire length.
Press into corners first, then press toward
edges. Use a soft clean cloth to press firmly
and remove any rippling along glue lines.
Check and re-press if necessary.
For corner mouldings,
re-install the shelves
while the adhesive
is setting.
Allow the adhesive to cure before installing the
shower or bath and/or using the enclosure.
Remove the plastic film from liner before use.
CONTACT & WARRANTY INFORMATION
KOHLER NZ LTD
NEW ZEALAND
Free Fax: 0800 664 488
Free Ph: 0800 100 382
www.englefield.co.nz
For warranty information, please visit our website.
KOHLER AUSTRALIA
AUSTRALIA
Free Ph: 1 800 ENGLEFIELD
(1 800 364 533)
www.englefield.com
Page 9
INSTALLATION INSTRUCTIONS
CLEANING INSTRUCTIONS
Use non-abrasive soap and warm water.
Avoid:
• harsh chemicals and disinfectants.
• abrasive cleaners
• solvent based cleaners
• acid or alkaline cleaners
• products containing ammonia or peroxides.
Wipe out the unit after each use to prevent
build-up of soap and scum.
Always read the label instructions on any
cleaner carefully before applying it to the
surface.
!
Read the Care & Maintenance
label on the wall and leave it
in place for the end user.
IMPORTANT
ENGLEFIELD
Advertisement
