Advertisement
DURACRYL WALL
DRILLING AND CUTTING DURACRYL
Small holes can be drilled with a twist drill, but the cutting edge MUST be backed off with an oil
stone (the sharp edge dulled). Large holes must be drilled with a hole saw.
Maximum drill size : 12 mm. Drill speeds: 6 mm x 1800 RPM ; 12 mm x 900 RPM.
If for any reason the Duracryl requires cutting, use a fine tooth hacksaw and proceed with caution.
Edges can be smoothed with a second-cut file and medium-fine sandpaper. If the surface of the
Duracryl happens to be damaged, it can be restored by polishing with an appropriate compound.
SEALANT & ADHESIVE
The recommended adhesive and sealants are:
• Sika Shower Bond
acrylic liner to the wallboard.
Usage: • 3 cartridges for 2 sided wall liners
• 4 cartridges for 3 sided wall liners
• Sika Sikasil NG (White)
acrylic liner to the shower tray or bath.
These are available in separate Adhesive &
Sealant Packs. Phone 0800 100 382 (NZ) or
1800 ENGLEFIELD (Australia) for stockists.
Each Pack contains enough adhesive/sealant
for a complete shower enclosure or shower
over bath installation.
The contents of these packs MUST NOT be
used to glue down the feet of shower trays.
16520A-0
Adhesive & sealant pack - 2 sided wall
liner for white framed showers.
16521A-SHP
Adhesive & sealant pack - 2 sided wall
liner for metallic/black framed showers.
16522A-0
Adhesive & sealant pack - 3 sided wall
liner for white framed showers.
16523A-SHP
Adhesive & sealant pack - 3 sided wall
liner for metallic/black framed showers.
to adhere the
to seal the
INSTALLATION INSTRUCTIONS
Page 3
ENGLEFIELD
Advertisement
