Advertisement
DURACRYL WALL
CONSTRUCTION REQUIREMENTS - SIDE RECESSED WALL
1) For symmetrical shower enclosures (eg: 1000x1000 corner or 900x900x900 alcove), the acrylic
liner is reversible. Decide on which wall will have the shelving encroach the framing cavity space
and ensure there is no interference or obstructions (eg: plumbing, electrical wires, insulation).
2) Construct timber framing as shown in
Profile shower tray (60-70mm sill height), the Side Recessed Shower Wall Liner is designed to be
compatible with standard 90mm deep framing with vertical studs at 400mm or 600mm centres,
and horizontal nogs at 800mm and 1600mm centres from the floor level. It is recommended that
an additional nog be placed approximately 150mm up from the floor to assist with wallboard fixing.
3) Trial fit the wallboard and mark the cavities to be cut out to allow for the moulded shelving as
shown in figure 5.
4) Carefully cut the wallboard and fix to the studs.
Fig. 5: Wallboard Preparation for Side Recessed Wall Liners
minimum 90mm
stud depth
cutout full height
between nogs
INSTALLATION INSTRUCTIONS
When paired with an Englefield Quick-Fit Low
400mm
(or full width between
studs at 400mm centres)
Page 5
recess for moulded
wall liner shelving
recess for shower tray
ENGLEFIELD
Advertisement
