Low Paper Sensor - Custom Audio Electronics VKP80III User Manual

5.5 Low paper sensor

The device provides as an accessory (see
sensor, use an M3 screw not supplied.
All the dimensions shown in following igures are in millimetres.
Low paper sensor
Low paper
sensor board
18.2
For the assembly procedure, proceed as follows:
1
Paper roll
Fix the low paper sensor board to the support by using an M3 screw not included.
For the correct functioning of the low paper sensor, comply with the measures specified.
chapter
MATERIAL INCLUDED
Low paper wiring
10
11) a low paper sensor with the cable (see following igure). To ix the
Connector
210
230
B
from 1 mm to 6 mm
MATERIAL NOT
Fixing screw M3
A
Low paper wiring
Spacer
Low paper sensor
Low paper sensor board
Support
INCLUDED
A+B
39