Setting High Temperature Maintenance; Setting Dhw Circulation - Viessmann VITOTRONIC SPS Operating Instructions Manual

Setting day/night changeover
Parameter
Operat.
Start day
End day

Setting high temperature maintenance

With high temperature maintenance, the heating water
in the circuit is circulated so that cold water does not
go directly to the cylinder.
Tap the following on-screen buttons:
1. If necessary, for the home screen
2. for the "Main menu"
Parameter
T maint.

Setting DHW circulation

Tap the following on-screen buttons:
1. If necessary, for the home screen
2. for the "Main menu"
3. "Set val."
"7-day program"
Parameter
Operat.
Monday on
Monday off
:
Sunday on
Sunday off
Circulation pumps can seize up if they are idle for a
long time.
"Anti-blocking prot."
Parameter
Weekday
Time
Dur.
(cont.)
Factory setting
07:00 h
22:00 h
Factory Min. Max.
setting
40 °C 25 °C 60 °C
Factory setting
05:00 h
22:00 h
05:00 h
22:00 h
Value
"Mo" to "Su"
hh:mm
min
Description
Status (day (On) / night (Off))
Time of changeover from night curve to day
curve
Time of changeover from day curve to night
curve
3. "Set val."
4. "Heat sink"
5. "Condenser"
6. "Valve condenser"
7. Set the required values.
Description
Set value for high temperature maintenance with
controlled pump
4. "Heat sink"
5. "HW"
6. "Pump DHW circ."
7. Set the required values.
Description
Status (On/Off)
Start time on Monday
Stop time on Monday
Start time on Sunday
Stop time on Sunday
The anti-blocking protection switches the circulation
pumps on for a short period at certain times.
Description
Day of the week when the circulation pump is
switched on.
Time at which the circulation pump is switched on.
Duration of the pump runtime
Settings
17