Settings
Setting cooling curves and heating curves
Setting heating curves for the heat sink
Tap the following on-screen buttons:
1. If necessary,
for the home screen
2.
for the "Main menu"
3. "Set val."
4. "Heat sink"
5. Select the system component, e.g. "Htg circ."
"Circ. 1".
Setting day/night changeover
Setting day/night changeover for the heat source
The "Heat source" includes the following system
components:
■
Coolant buffer cylinder "Coolant buff. cyl."
■
Cooling circuits "Circ. 1" to "Circ. 4"
Tap the following on-screen buttons:
1. If necessary,
for the home screen
2.
for the "Main menu"
Parameter
Operat.
Start day
End day
Setting day/night changeover for the heat sink
The "Heat sink" includes the following system compo-
nents:
■
Heating water buffer cylinder "HWB"
■
Heating circuits "Circ. 1" to "Circ. 4"
Tap the following on-screen buttons:
1. If necessary,
for the home screen
2.
for the "Main menu"
*1
The names can be changed.
16
*1
Factory setting
07:00 h
22:00 h
*1
(cont.)
6. "Heating curve"
7. Set the required values.
"Day"
Flow temperatures, standard mode
"Night" Flow temperatures, reduced mode
The flow temperature values are each assigned to
an outside temperature value.
3. "Set val."
4. "Heat source"
5. Select the system component, e.g. "Cool.circ"
"Circ. 1".
6. "Day/night changeover cooling curve"
7. Set the required values.
Description
Status (day (On) / night (Off))
Time of changeover from night curve to day
curve
Time of changeover from day curve to night
curve
3. "Set val."
4. "Heat sink"
5. Select the system component, e.g. "Htg circ."
"Circ. 1".
6. "Day/night changeover htg curve"
7. Set the required values.