Mechanical Connections; Drawbars - Mounting The Drawbar Extension; Transmission Shaft - Operator's Safety; Transmission Shaft - Installation - Hardi COMMANDER TWIN FORCE Series Instruction Book

Mechanical connections

Drawbars - Mounting the drawbar extension

The extension piece is inserted into the opening for the drawbar,
fastened by three main bolts through the three holes (A) and secu-
red by locknuts.
Following drawbar extensions are available.
Low D33/50 swivel
Low D50 hitch
Low K80 Zugkugel
High K80 Zugkugel
High Zugmaul

Transmission shaft - Operator's safety

1. Always STOP ENGINE before attaching the transmission shaft to tractor P.T.O. - most tractor P.T.O. shafts can be rotated
by hand to facilitate spline alignment, when engine is stopped.
2. When attaching the shaft, make sure that the snap lock is FULLY ENGAGED - push and pull shaft until it locks.
3. Always keep protection guards and chains intact and make sure that it covers all rotating parts, including CV-joints at
each end of the shaft. Do not use without protection guard.
4. Do not touch or stand on the transmission shaft when it is rotating - safety distance: 1.5 meter.
5. Prevent protection guards from rotating by attaching the chains allowing sufficient slack for turns.
6. Make sure that protection guards around tractor P.T.O. and implement shaft are intact.
7. Always STOP ENGINE and remove the ignition key before carrying out maintenance or repairs to the transmission shaft
or implement.
DANGER! ROTATING TRANSMISSION SHAFTS WITHOUT PROTECTION GUARDS ARE FATAL.

Transmission shaft - Installation

First installation of the transmission shaft is done in the following
way:
1. Attach sprayer to tractor and set sprayer height in the position
with shortest distance between the tractor and sprayer pump P.T.O.
shafts.
2. Stop engine and remove ignition key.
3. If transmission shaft must be shortened, the shaft is pulled apart.
Fit the two shaft parts at tractor and sprayer pump and measure
how much it is necessary to shorten the shaft. Mark the protection
guards.
WARNING! The shaft must always have a minimum overlap.
The size of this overlap depends on the pump model:
4 - Sprayer setup
4.3