Safety Precautions - Crop Protection Chemicals; Filling Chemicals Through Tank Lid - Hardi COMMANDER TWIN FORCE Series Instruction Book

Safety precautions - crop protection chemicals

Always be careful when working with crop protection chemicals!
WARNING! Always wear correct protective clothing before handling chemicals!
Personal protection
Depending on chemical type, protective gear /equipment should be worn to avoid contact with the chemicals, e.g.:
• Gloves
• Waterproof boots
• Headgear
• Respirator
• Safety goggles
• Chemical resistant overall
WARNING! Protective clothing/equipment should be used when preparing the spray liquid, during the spray job
and when cleaning the sprayer. Follow the chemical manufacturer's instructions given on the chemical label.
WARNING! It is always advisable to have clean water available, especially when filling the sprayer with the chemi-
cal.
WARNING! Always clean the sprayer carefully and immediately after use.
WARNING! Only mix chemicals in the tank according to directions given by the chemical manufacturer.
WARNING! Always clean the sprayer before changing to another chemical.

Filling chemicals through tank lid

The chemicals are filled through the tank lid - Note instructions on the chemical container!
WARNING! Be careful not to slip or splash chemicals when carrying chemicals up to the tank lid!
1. Make sure the control unit is switched off.
2. Set the MANIFOLD valves to correct position. Suction SmartValve
"Suction from main tank", AgitationValve towards "Agitation".
3. Engage the pump and set P.T.O. revolutions to recommended
pump r.p.m.
4. Add the chemicals through the main tank hole.
5. When the spray liquid is well mixed, turn handle on the suction
SmartValve towards "suction from Main tank" and turn pressure
SmartValve towards "Spraying" position. Keep P.T.O. engaged so the
spray liquid is continuously agitated until it has been sprayed on the
crop.
5 - Operation
5.7